About this asset

Flared funnel commercial kitchen P-trap Revit family incorporates a wide cone receptor transition and an integrated MEP pipe discharge connector. Rendered in clean neutral tones, the component consists of an upper conical funnel receptor transitioning into a vertical downpipe and a sweeping trap bend. A continuous tubular profile forms the water seal before sweeping into an outlet spigot oriented horizontally. The funnel rim provides an open top aperture designed to capture air-gap equipment discharge, while the discharge terminus incorporates a clearly defined circular conduit profile with an integrated system connection axis. Proportions balance the tall riser column against a compact trap curve to accommodate sub-counter and below-slab plumbing clearance envelopes.

The download is a 379 KB file containing a Revit family (.rfa). Load it into a project from the Insert tab with Load Family, then place it like any other component of its category; it schedules and tags with the rest of your model.

Load this RFA family directly into Autodesk Revit project templates to coordinate MEP drainage services. The built-in pipe connector aligns cleanly with sanitary piping runs, allowing automated routing and system classification. Designers can establish elevation parameters beneath kitchen equipment fixtures, check spatial clearances against adjacent casework or structure, and run clash detection against architectural casework and mechanical floor penetrations.

Engineered for back-of-house commercial kitchens, restaurant prep zones, culinary schools, and healthcare sculleries, this trap model supports indirect waste collection from combi ovens, ice machines, and commercial dishwashers. Specifiers typically search for indirect waste funnels, kitchen hub drains, open site drain traps, and air gap receptors during technical design and coordination stages. It pairs naturally with stainless steel prep sinks, floor drains, grease interceptors, and commercial catering equipment layouts.