About this asset

Featuring top intake grilles and a slim contoured profile, this wall-mounted fan coil unit Revit family models compact indoor climate terminal equipment. Designed with an elongated horizontal body, the casing features a curved front fascia transitioning cleanly into flat side caps. Horizontal intake louvres extend across the upper face to allow return air intake, while a narrow horizontal discharge slot runs along the lower leading edge for conditioned supply air. The outer enclosure is finished in matte neutral off-white plastic with dark grey side and rear interfaces, mimicking typical indoor ductless split or hydronic room units. A small indicator window sits recessed near the bottom corner.

The download is a 379 KB file containing a Revit family (.rfa). Load it into a project from the Insert tab with Load Family, then place it like any other component of its category; it schedules and tags with the rest of your model.

In Revit, load the RFA component directly into project templates or MEP coordination models. Place the family against finished partition walls or bulkheads at the specified mounting height, verifying clear zone clearances for airflow and service access. The lightweight geometry ensures clean performance in floor plans, sections, and BIM coordination models without excessive face counts slowing down navigation or clash detection workflows.

Well-suited for residential apartments, hotel guest rooms, light commercial offices, and educational facilities where space-saving terminal units are specified. The family is typically placed alongside thermostat sensors, MEP risers, and condensate drain lines during technical design stages. Interior designers and building service engineers searching for wall mounted FCU components, ductless split indoor units, or localized room air conditioners can incorporate this asset seamlessly into coordinated interior elevations and spatial layouts.